The best course of action is to take a toothbrush, dip it in isopropyl alcohol, shake it to remove excess, and scrub the offending slot or port. Do not use Windex/Amonia based cleaning products as they leave a massive residue inside machines that is difficult to completly remove from sockets and cartridge connectors, and can after a while cause a short or arching.Ĭonsoles Cartridge/Expansion Slots The section applies to any port or slot that a circuit board (cartridge, memory card, etc.) or cord (controller, A/V, etc.) attaches to on the console. You can buy a bottle for only a few dollars at any drug store, and one bottle will last you a long time. If you don't have isopropyl alcohol, get some. A rubber eraser ( not on a pencil) for taking off stubborn corrosion on edge contacts.This is why you should use 90% or higher. percentage) is low, the alcohol won't evaporate as quickly. The point of using alcohol is that it evaporates very quickly.You can find it in a hardware store in the paint section. Alternativly, Denatured Alcohol as it contains none of these other chemicals.Check the label to make sure they didn't add acetone, as it damages (fogging on bottom side) CDs and leaves a residue on cartridges and connectors, over time this build up causes problems.70 percents have other adulterant chemicals in them. Isopropy alcohol, at least 90 percent.The most important tools you'll need for cleaning most parts of a console are Occasional cleaning of game consoles is recommend to extend their longevity and restore functionality.

Console cleaner